DC01 | 1.0330

DC01 represents the basic grade of the DC steel family and is also known under the former designations St12 or FeP01. This grade can be used for simple forming operations such as bending, coining, beading and drawing.

DC01 - send request!

Mild low-carbon steel for cold forming

DC01 | 1.0330: Properties according to DIN EN 10 130

Steel type

Short designation	VDA239-100	Material number
DC01	CR1	1.0330

* Comparative grade, therefore minor deviations from DIN EN values possible

DC01 | 1.0330: Mechanical properties (transverse)

Yield strength¹⁾ Re MPa max.	Tensile strength Rm MPa	Elongation at fracture²⁾% min. A80	Anisotropy r90³⁾⁴⁾min.	Strain hardening exponent n90³⁾min.
280	270-410	28	-	-

DC01 | 1.0330: Chemical composition (heat analysis)

Percentage by weight % max.
C	P	S	Mn	Ti
0.12	0.045	0.045	0.60	-

Your product of choice: DC01 | 1.0330

Send request!

1) Where no yield strength is defined, the respective values shall apply to the 0.2 % proof stress (Rp0.2) or to the lower yield strength (ReL). For thicknesses ≤ 0.7 mm but > 0.5 mm, the maximum yield strength values may be 20 MPa higher. In case of thicknesses ≤ 0.5 mm, the maximum yield limits may be 40 MPa higher.

2) For thicknesses ≤ 0.7 mm but > 0.5 mm, the minimum elongation at fracture may be 2 units lower. For thicknesses ≤ 0.5 mm, the minimum elongation at fracture may be 4 units lower.

3) The r90 and n90 values apply to product thicknesses ≥ 0.5 mm only.

4) For thicknesses > 2 mm, the r90-value is reduced by 0.2.